Re: Disconnecting zones...
Well TaruBst asked for an update post-reinstall:
I'm all good apparrently. I was able to log on and get out of the airship dock also I went back to Sauromouge Ch. (sp) and had no ffxi-4001 error. I did the update hooked up directly to my modem (cable hi-speed) and then did my zone testing from behind my router. I did encounter 1 R0 error in Carpenters Bay however I was able to zone back into S.Sandy without getting kicked.
That said I'm wondering if I encountered this issue, not saying anyone else has but it's a possibillity.
During the update I was dropped around 3x before getting it installed. I'm thinking it is possible that the repeated drops could have caused some data corruption which caused some areas to not-work properly. Therefore a re-install and re-update should correct any problems, which it apparrently has in my case. (I chose the minor re-install, the one that leaves your macros intact.) Also this could explain why SE sees no problems at thier end.
If anyone with more technical savvy and further background information could either verify this as a possibillty or de-bunk it as, well...bunk. Please do so before we see everyone start re-installng, it would be greatly appreciated.
Good luck
Well TaruBst asked for an update post-reinstall:
I'm all good apparrently. I was able to log on and get out of the airship dock also I went back to Sauromouge Ch. (sp) and had no ffxi-4001 error. I did the update hooked up directly to my modem (cable hi-speed) and then did my zone testing from behind my router. I did encounter 1 R0 error in Carpenters Bay however I was able to zone back into S.Sandy without getting kicked.
That said I'm wondering if I encountered this issue, not saying anyone else has but it's a possibillity.
During the update I was dropped around 3x before getting it installed. I'm thinking it is possible that the repeated drops could have caused some data corruption which caused some areas to not-work properly. Therefore a re-install and re-update should correct any problems, which it apparrently has in my case. (I chose the minor re-install, the one that leaves your macros intact.) Also this could explain why SE sees no problems at thier end.
If anyone with more technical savvy and further background information could either verify this as a possibillty or de-bunk it as, well...bunk. Please do so before we see everyone start re-installng, it would be greatly appreciated.
Good luck
Comment